Drill pocket holes in the bottom edge of each divider piece. Position the supports under the bottom, securing the supports to the bottom and sides using glue and 1-1/4″ brad nails.Ĭut the pieces for the dividers and cut the notches using a jigsaw. Secure the stretchers to the upper edge of the sides using glue and 1-1/4″ pocket hole screws. Drill pocket holes in each end of the pieces for the upper stretchers. Secure the bottom to the sides, locating the bottom 1-1/2″ up from the bottom edge of the sides, using glue and 1-1/4″ pocket hole screws.Ĭut the pieces for the upper stretchers and the lower supports. With the pocket hole jig set for 3/4″ material, drill pocket holes in each end of the bottom piece. 2 – 1/4″ plywood at 9-1/4″ x 15-3/4″ – Door PanelsĬlick on the drawings for a larger view! Step OneĮdge banding will be applied to the exposed edges of the plywood prior to assembly!Ĭut the pieces for the sides and the bottom.1 – 1×3 (ripped to 2″ wide) at 51″ – Lower Front Trim.4 – 1×2 at 49-1/2″ – Upper Stretchers & Lower Supports.* If using pegboard for the back, 1 – 2′ x 4′ sheet of 1/4″ plywood will be needed for the door panels Cut List: 1 – 4′ x 8′ sheet of 1/4″ plywood or pegboard*. Finishing supplies (primer & paint, or stain, sealer).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |